Fittings
|
|
|
Elbows 220-23-33
- Product Type
- Mini-Ball Elbow
- Description
- 1/2 Male Solder X 5/8 OD Comp
- Material
- Regular Brass
Specifications
- Pattern
- Angle
- Finish
- Rough Brass
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 1/2
Outlet
- Outlet Pipe Type
- Copper
- Outlet Size
- 5/8 OD
Packaging Details
- Box / Case
- 24 / 144
Dimensions
- Unit Weight (lbs.)
- 0.3639
Instructions for 220-23-33
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
MALE SOLDER: Do not dismantle valve – solder in open position. Clean mating part and valve end with emery cloth & apply flux to both. Valve must be bottomed in mating part. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
Features and Benefits
dahl can produce thousands of models of common and specialty end-of-line elbows.
Need something special? Just ask for it and it will ship from dahl.
Every fitting is tested before leaving our factory.
Certifications
NSF/ANSI 61