Fittings
|
|
|
Tees Vent 14-J12-51
- Product Type
- Vent Tee
- Description
- 3/4 Fem. Solder X #12 JIC Male Flare X 1/4 FIP
- Material
- Regular Brass
Specifications
- Pattern
- Tee
- Finish
- Rough Brass
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 3/4
Outlet
- Outlet Pipe Type
- Copper
- Outlet Size
- #12
Branch
- Branch Pipe Type
- Iron
- Branch Size
- 1/4
Packaging Details
- Box / Case
- 24 / 144
Instructions for 14-J12-51
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
FEMALE SOLDER: Do not dismantle valve – solder in open position. Clean pipe and valve socket with emery cloth, & apply flux to both. Pipe must be square and bottomed in socket. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
MALE FLARE: Do not use pipe dope or PTFE tape. Tighten firmly with wrench. DO NOT OVER-TIGHTEN.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.