Fittings
|
|
|
Tees 23-82-53
- Product Type
- Mini-Ball Tee
- Description
- 1/2 Male Solder X 1/2 OD Male Flare X 1/2 FIP
- Material
- Regular Brass
Specifications
- Pattern
- Tee
- Finish
- Plated
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 1/2
Outlet
- Outlet Pipe Type
- Copper
- Outlet Size
- 1/2 OD
Branch
- Branch Pipe Type
- Iron
- Branch Size
- 1/2
Packaging Details
- Box / Case
- 24 / 144
Dimensions
- Unit Weight (lbs.)
- 0.3922
Instructions for 23-82-53
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
MALE SOLDER: Do not dismantle valve – solder in open position. Clean mating part and valve end with emery cloth & apply flux to both. Valve must be bottomed in mating part. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
MALE FLARE: Do not use pipe dope or PTFE tape. Tighten firmly with wrench. DO NOT OVER-TIGHTEN.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.
Features and Benefits
dahl can produce thousands of models of common and specialty end-of-line tees.
Need something special? Just ask for it and it will ship from dahl.
Every fitting is tested before leaving our factory.
Certifications
NSF/ANSI 61
Submittal Sheet
TDS 368 (TEE 23-82-53).pdf