mini-ball™ Valves
|
|
|
In-Line Stops & Isolation 211-33-64 (Copper)
- Product Type
- Stop & Isolation Valve
- Description
- 5/8 OD Comp X 3/4 MIP
- Material
- Regular Brass
Specifications
- Pattern
- Angle
- Finish
- Plated
- Operation
- Plated Handle
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 5/8 OD
Outlet
- Outlet Pipe Type
- Iron
- Outlet Size
- 3/4
Packaging Details
- Box / Case
- 18 / 108
Dimensions
- Unit Weight (lbs.)
- 0.6083
Instructions for 211-33-64
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or an insert may be required.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.
Features and Benefits
In-Line Stop with Drain Screw and O-ring seal.
Hundreds of models available.
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
Certifications
NSF/ANSI 61