mini-ball™ Valves
|
|
|
In-Line Stops & Isolation 611-33-PX3 (Copper)
- Product Type
- Stop & Isolation Valve
- Description
- 5/8 OD Comp x 1/2 Crimpex
- Material
- Lead-Free Brass
Specifications
- Pattern
- Angle
- Finish
- Plated
- Operation
- Plated Handle
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 5/8 OD
Outlet
- Outlet Pipe Type
- PEX
- Outlet Size
- 1/2
Packaging Details
- Box / Case
- 24 / 144
Instructions for 611-33-PX3
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
CRIMPEX (Crimp for PEX): Follow tube manufacturer's instructions. Warning: Do not attempt to use PEX connections with Poly-B tubing or vice versa.
Features and Benefits
In-Line Stop with Drain Screw and O-ring seal.
Hundreds of models available.
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
ASTM
ASTM F1807
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5
Submittal Sheet
TDS 619 (33-PX3).pdf