mini-ball™ Valves
|
|
|
In-Line Stops & Isolation 615-23-30
- Product Type
- In-Line Stops & Isolation
- Description
- 1/2 Male Solder X 1/4 OD Comp, Blue Handle
- Material
- Lead-Free Brass
Specifications
- Pattern
- Angle
- Finish
- Plated
- Operation
- Blue Handle
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 1/2
Outlet
- Outlet Pipe Type
- Copper
- Outlet Size
- 1/4 OD
Packaging Details
- Box / Case
- 24 / 144
Instructions for 615-23-30
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
MALE SOLDER: Do not dismantle valve – solder in open position. Clean mating part and valve end with emery cloth & apply flux to both. Valve must be bottomed in mating part. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5