Water Hammer Valves / Fittings
|
|
|
Hose 221-01-04-14WHA
- Product Type
- Hose Valve with Integral Water Hammer Arrester
- Description
- 1/2 Fem. Solder or 1/2 MIP X Male Hose X Water Hammer Arrester
- Material
- Regular Brass
Specifications
- Pattern
- Angle
- Finish
- Rough Brass
- Operation
- Plated Handle
Inlet
- Inlet Pipe Type
- Iron
- Inlet Size
- 1/2
Outlet
- Outlet Pipe Type
- Hose
Packaging Details
- Box / Case
- 12 / 72
Operating Specifications
- Working Pressure
- 250 PSI
- Working Temperature
- 250
- Cv Valve
- 1.8
Dimensions
- Unit Weight (lbs.)
- 0.5300
Instructions for 221-01-04-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.
FEMALE SOLDER: Do not dismantle valve – solder in open position. Clean pipe and valve socket with emery cloth, & apply flux to both. Pipe must be square and bottomed in socket. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
HOSE: Tighten firmly. DO NOT OVER-TIGHTEN.
Position arrester at any angle.
Features and Benefits
Stops banging pipes!
Convert washing machine supplies to 1/4 turn in seconds and eliminate water hammer at the same time!
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
Certifications
ASSE 1010