Water Hammer Valves / Fittings
|
|
|
In-line Stops and Isolation 511-QG3-01-14WHA
- Product Type
- In-line Stop and Isolation Valve with Integral Water Hammer Arrester
- Description
- 1/2 QUICK-GRIP X 1/2 Fem. Solder or 1/2 MIP x Water Hammer Arrester
- Material
- Lead-Free Brass
Specifications
- Pattern
- Straight
- Finish
- Plated
- Operation
- Plated Handle
Inlet
- Inlet Pipe Type
- Copper, PEX, CPVC
- Inlet Size
- 1/2
Outlet
- Outlet Pipe Type
- Iron
- Outlet Size
- 1/2
Branch
- Branch Pipe Type
- Water Hammer Arrester
Packaging Details
- Box / Case
- 8 / 48
Instructions for 511-QG3-01-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
QUICK-GRIP™ For 1/2" Copper, PEX or CPVC pipe, in accessible locations only. NOT for Kitec® , PEX-AL-PEX, Poly-B, plated pipe. Cut pipe & de-burr. Mark pipe 1-1/8" (2.9 cm) from end. (PEX only: Install pipe insert). QUICK-GRIP™ must be free of debris. Push valve onto pipe to the mark. Pull to test joint. Removal: Remove Locking Clip, depress end of QUICK-GRIP™, pull valve off.
FEMALE SOLDER: Do not dismantle valve – solder in open position. Clean pipe and valve socket with emery cloth, & apply flux to both. Pipe must be square and bottomed in socket. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.
Position arrester at any angle.
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5
ASSE 1010
ASSE 1061