Water Hammer Valves / Fittings
|
|
|
In-line Stops and Isolation 611-33-01-14WHA
- Product Type
- In-line Stop and Isolation Valve with Integral Water Hammer Arrester
- Description
- 5/8 OD Comp X 1/2 Fem. Solder or 1/2 MIP X Water Hammer Arrester
- Material
- Lead-Free Brass
Specifications
- Pattern
- Angle
- Finish
- Plated
- Operation
- Plated Handle
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 5/8 OD
Outlet
- Outlet Pipe Type
- Iron
- Outlet Size
- 1/2
Packaging Details
- Box / Case
- 12 / 72
Operating Specifications
- Working Pressure
- 250 PSI
- Working Temperature
- 250
- Cv Valve
- 1.8
Instructions for 611-33-01-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or an insert may be required.
FEMALE SOLDER: Do not dismantle valve – solder in open position. Clean pipe and valve socket with emery cloth, & apply flux to both. Pipe must be square and bottomed in socket. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
NPT THREAD: Clean pipe threads and cover them with pipe dope or PTFE tape. Tighten firmly while gripping hex on end of valve. DO NOT OVER-TIGHTEN.
Position arrester at any angle.
Features and Benefits
Stops banging pipes!
With integral AA water hammer arrester.
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5
ASSE 1010