Water Hammer Valves / Fittings
|
|
|
Supply Stops 516SS-33-31-14WHA
- Product Type
- Supply Stop with Integral Water Hammer Arrester
- Description
- 5/8 OD Comp X 3/8 OD Comp X Water Hammer Arrester
- Material
- Lead-Free Brass
Specifications
- Pattern
- Straight
- Finish
- Plated
- Operation
- Loose Key with Screwdriver Slot
Inlet
- Inlet Pipe Type
- Copper
- Inlet Size
- 5/8 OD
Outlet
- Outlet Pipe Type
- Copper Compression
- Outlet Size
- 3/8 OD Comp
Branch
- Branch Pipe Type
- Water Hammer Arrester
Packaging Details
- Box / Case
- 12 / 72
Instructions for 516SS-33-31-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
Position arrester at any angle.
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5
ASSE 1010