Water Hammer Valves / Fittings
|
|
|
Supply Stops 616SS-PX3-31-14WHA
- Product Type
- Supply Stop with Integral Water Hammer Arrester
- Description
- 1/2 Crimpex X 3/8 OD Comp X Water Hammer Arrester
- Material
- Lead-Free Brass
Specifications
- Pattern
- Angle
- Finish
- Plated
- Operation
- Loose Key with Screwdriver Slot
Inlet
- Inlet Pipe Type
- PEX
- Inlet Size
- 1/2
Outlet
- Outlet Pipe Type
- Copper Compression
- Outlet Size
- 3/8 OD Comp
Branch
- Branch Pipe Type
- Water Hammer Arrester
Packaging Details
- Box / Case
- 12 / 72
Instructions for 616SS-PX3-31-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
CRIMPEX (Crimp for PEX): Follow tube manufacturer's instructions. Warning: Do not attempt to use PEX connections with Poly-B tubing or vice versa.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or an insert may be required.
Position arrester at any angle.
ASTM
ASTM F1807
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5
ASSE 1010
Documentation
Water Hammer Arrester Valves
Water Hammer Arrester Valves (French)
Options
Options (French)
Submittal Sheet
TDS 631 (616SS-PX3-31-14WHA).pdf