Supply Stops 621-23-30
| Description | 1/2 Male Solder X 1/4 OD Comp |
|---|---|
| Product Type | Supply Stop |
| Inlet Pipe Type | Copper |
| Outlet Pipe Type | Copper |
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
Specifications
| Material | Lead-Free Brass |
|---|---|
| Inlet Size | 1/2 |
| Pattern | Angle |
| Inlet Connection | Male Solder |
| Finish | Rough Brass |
| Operation | Plated Handle |
| Outlet Size | 1/8 |
| Inlet | 23 |
| Outlet Connection | 1/4 OD Comp |
| Outlet | 30 |
| Box / Case | 24 / 144 |
Instructions
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
MALE SOLDER: Do not dismantle valve – solder in open position. Clean mating part and valve end with emery cloth & apply flux to both. Valve must be bottomed in mating part. DO NOT re-position valve after soldering. Clean with water and dry. Let cool before operating.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer’s instructions; Special ring, nut, or insert may be required.
Certifications
- USA Patent
- CSA
- UPC
- NSF/ANSI/CAN 372 NSF/ANSI/CAN 61: Q≤0.5
Where to Buy
Find dahl valves in hundreds of wholesale and retail locations across the US and Canada.