Press Valves 611-FP3-31
| Description | 1/2 Female Press x 3/8 OD Comp |
|---|---|
| Product Type | Supply Stop |
| Inlet Pipe Type | Copper |
| Outlet Pipe Type | Copper |
dahl valves and fittings are designed and manufactured in Canada, and backed by our lifetime transferable warranty.
Made with 100% North American materials, specifically with premium quality US lead-free brass, every dahl valve is tested for quality before leaving the plant.
More than a valve, dahl offers a lifetime of reliability.
Specifications
| Material | Lead-Free Brass |
|---|---|
| Pattern | Angle |
| Finish | Plated |
| Operation | Plated Handle |
| Inlet | FP3 |
| Inlet Size | 1/2 |
| Inlet Connection | Female Press |
| Outlet | 31 |
| Outlet Size | 1/4 |
| Outlet Connection | 3/8 OD Comp |
| Box / Case | 24 / 144 |
Instructions
KEEP IN PACKAGING until installation to remain free of debris. Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
FEMALE PRESS
APPROVED PIPE: hard drawn copper only ASTM B88 types K, L, M.
MINIMUM DISTANCES: 1/4” when pressing near soldered fitting; solder 3 pipe dia. away from existing press fitting (9 for brazing).
CUT THE PIPE SQUARE using pipe cutter or fine saw.
DEBURR PIPE EDGES so all sharp edges are removed or leakage may result.
CHECK THE FITTING is clean, free of debris and O-ring is undamaged and seated correctly.
MARK INSERTION DEPTH 13/16” from end of pipe.
SLIDE THE FITTING on pipe while rotating slightly to marked depth. Pipe end must contact the stop.
PRESS THE FITTING using correct press tool & jaws, following tool manufacturer’s instructions.
INSPECT THE PRESSED JOINT to ensure proper crimp and pipe has remained fully inserted.
COMPATIBLE TOOLS* include press tools with compact/standard jaws from: RIDGID; Milwaukee; DeWalt; REMS; or VUS profile jaws.
*Contact dahl Valve Limited for more information.
COMPRESSION ON COPPER PIPE:
Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER TIGHTEN. Compression on plastic tube: Follow tube manufacturer’s instructions; Special ring, nut, or insert may be required.
Certifications
- CSA
- UPC
- NSF/ANSI/CAN 372 NSF/ANSI/CAN 61: Q≤0.5
Where to Buy
Find dahl valves in hundreds of wholesale and retail locations across the US and Canada.