Water Hammer Valves / Fittings
|
|
|
Supply Stops 611-46-31-14WHA
- Product Type
- Supply Stop with Integral Water Hammer Arrester
- Description
- 1/2 Fem. CPVC X 3/8 OD Comp X Water Hammer Arrester
- Material
- Lead-Free Brass
Specifications
- Pattern
- Angle
- Finish
- Plated
- Operation
- Plated Handle
Inlet
- Inlet Pipe Type
- CPVC
- Inlet Size
- 1/2
Outlet
- Outlet Pipe Type
- Copper
- Outlet Size
- 3/8 OD
Packaging Details
- Box / Case
- 12 / 72
Instructions for 611-46-31-14WHA
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
FEMALE CPVC: Cut pipe squarely and de-burr. Apply glue according to glue manufacturer's instructions. Bottom pipe into valve. Twist one quarter turn to spread glue.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
Position arrester at any angle.
Features and Benefits
Stops banging pipes!
With integral AA water hammer arrester.
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
ASTM
ASTM D2846
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5
ASSE 1010
Documentation
Water Hammer Arrester Valves
Water Hammer Arrester Valves (French)
Submittal Sheet
TDS 638 (611-46-31-14WHA).pdf