Supply Stops 611-33-L5-14WHA
| Description | 5/8 OD Comp X 1/2 or 7/16 OD Slip Joint X Water Hammer Arrestor |
|---|---|
| Product Type | Supply Stop with Integral Water Hammer Arrestor |
| Inlet Pipe Type | Copper |
| Outlet Pipe Type | Copper |
Stops banging pipes!
With integral AA water hammer Arrestor.
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
Specifications
| Material | Lead-Free Brass |
|---|---|
| Inlet Size | 1/2 |
| Pattern | Angle |
| Inlet Connection | 5/8 OD Comp |
| Finish | Plated |
| Operation | Plated Handle |
| Outlet Size | 1/2 |
| Inlet | 33 |
| Outlet Connection | Slip Joint |
| Branch Connection | Water Hammer Arrester |
| Outlet | L5 |
| Branch | 14WHA |
| Working Temperature | 250 |
| Working Pressure | 250 psi |
| Box / Case | 12 / 72 |
Instructions
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
SLIP JOINT: Do not use pipe dope or tape. Pipe must be clean, round, cut square. Choose ring that fits snugly on the pipe, discard the other. Slide nut and ring over pipe. Create bead 3/8" to 1/2" from end of pipe with beading tool. Slide grommet on pipe, large end against bead. Attach to valve & tighten. DO NOT OVERTIGHTEN.
Position Arrestor at any angle.
Certifications
- CSA
- UPC
- NSF/ANSI/CAN 372 NSF/ANSI/CAN 61: Q≤0.5
- ASSE 1010
Downloads
Where to Buy
Find dahl valves in hundreds of wholesale and retail locations across the US and Canada.