mini-ball™ Valves
|
|
|
Supply Stops 611-QG3-31 (Push-Fit)
- Product Type
- Supply Stop
- Description
- 1/2 QUICK-GRIP X 3/8 OD Comp
- Material
- Lead-Free Brass
Specifications
- Pattern
- Angle
- Finish
- Plated
- Operation
- Nickel Plated Handle
Inlet
- Inlet Pipe Type
- QUICK-GRIP
- Inlet Size
- 1/2 QUICK-GRIP
Outlet
- Outlet Pipe Type
- Copper Compression
- Outlet Size
- 3/8 OD Comp
Packaging Details
- Box / Case
- 12 / 72
Dimensions
- Unit Weight (lbs.)
- 0.6473
Instructions for 611-QG3-31
Turn off water supply. Install product. Turn on water supply, check for leaks. dahl assumes no responsibility for failure due to improper installation. Abide by local plumbing codes. Do not expose to corrosive agents.
QUICK-GRIP™ For 1/2" Copper, PEX or CPVC pipe, in accessible locations only. NOT for Kitec® , PEX-AL-PEX, Poly-B, plated pipe. Cut pipe & de-burr. Mark pipe 1-1/8" (2.9 cm) from end. (PEX only: Install pipe insert). QUICK-GRIP™ must be free of debris. Push valve onto pipe to the mark. Pull to test joint. Removal: Remove Locking Clip, depress end of QUICK-GRIP™, pull valve off.
COMPRESSION ON COPPER PIPE: Do not use pipe dope or PTFE tape. Pipe must be clean, de-burred, round, & cut square. Slide nut, then ring, then valve onto pipe. Tighten firmly with small wrench. DO NOT OVER-TIGHTEN. Compression on plastic tube: Follow tube manufacturer's instructions; Special ring, nut, or insert may be required.
Features and Benefits
Every valve is tested before leaving our factory.
They may build them with something else, but they fix them with these.
Certifications
NSF/ANSI/CAN 372
NSF/ANSI/CAN 61: Q≤0.5
ASSE 1061